Product information Elastic joint sealer
ESCOSIL®-2000 Silicone joint sealant
Technical Data: Basis:
pure, unmodified acetate curing silicone sealant
Colours:
transparent, white, silver grey, grey, pearl grey, manhatten, mid grey 98, cement grey, beige, pergamon, nut brown, titanium grey, slate grey, graphite
Consistency: paste Application temperature: +5 °C to +35 °C Curing:
approx. 2–3 mm/ day, at +23 °C and 50 % relative humidity
Skin formation:
approx. 8–12 minutes, at +23 °C and 50 % relative humidity
Temperature resistance:
-40 °C to +180 °C
Permissible movement accommodation:
25 %
Shore-A-hardness:
approx. 30, acc. to DIN 53505
Consumption:
dependent on joint cross-section and depth
Packaging: 310 ml, polyethylene cartridges, (12 × 310 ml tubes per box)
nut brown
silver grey
beige
titanium grey
grey
pergamon
slate grey
manhattan
mid grey 98
graphite
* Colour differences may exist due to print limitations.
cement grey
SCHOMBURG GmbH & Co. KG Aquafinstrasse 2–8 D-32760 Detmold (Germany) phone +49-5231-953-00 fax +49-5231-953-108 email export@schomburg.de www.schomburg.com
TS/CoS/JD
pearl grey
49/15
Areas of application: • ESCOSIL®-2000 is used in sanitary applications for sealing movement and connecting joints between tiled finishes and wash-basins, bath-tubs, shower trays, architraves and window frames in dry, wet areas and wet rooms.
white
Subject to changes. Consult current technical data sheet for most recent information.
Colour illustration*:
2 05590
Product application: Once any applied primer has dried (see technical data sheet), filling can be undertaken with ESCOSIL®-2000. Using a caulking gun, extrude ESCOSIL®-2000 into the prepared joint. Then smooth the applied sealant before it forms a skin, with a suitable tool and water containing a surfactant. This process ensures the material is pressed into the joint and at the same time pressed against the contact surfaces. Follow the general rules for producing elastic joints.
Properties: • Non slump • Acetic cross-linking • Elastic • Contains a fungicide • Resistant to chemicals and chlorine • Weather-, UV- and ageing-resistant • Watertight • For walls and floors
Information about the emission level of volatile compounds in indoor air, which pose a health risk by inhalation, on a scale from class A+ (very low emissions) to C (high emissions).
Please take supplementary advice from the current valid technical data sheet.
1 ESCOSIL®-2000 and suitable tool
2 Installation of a suitable backing strip
3 Application of ESCOSIL®-2000
4 Application of a suitable smoothing agent
5 Striking off excess silicone sealant
6 Subsequent smoothing
Application: The surfaces with which the sealant will be in contact must be dry (concrete < 4% moisture), clean, dust free as well as free from all substances, which act as separating agents (e.g. oil, paint residues, sealants, cement slurries, grout residues etc.). Whilst ESCOSIL®-2000 hardens, no moisture may be allowed to penetrate from the edges or the base of the joint.