back

Installation on magnesite and xylolite screed (MA)

Direct contact between cement-based tile adhesives and magnesite screeds leads to the destruction of the magnesite screed due to a chemical reaction. Rear moisture permeation from the substrate must be excluded using appropriate measures. Mechanically roughen the magnesite substrate, prime with the epoxy resin ASODUR-GBM and whilst the primer is still wet, broadcast to excess with 0.5 - 1.0 mm quartz sand. Tiles can be installed after waiting a further 12 – 16 hours approximately.

Print page
PRIMING

Resin primer based on epoxy resins

LEVELLING

Levelling compound for floors, when using on magnesite screeds do not exceed a max thickness of 15 mm

TILE INSTALLATION

Accelerated hardening flow bed flexible mortar

Flexible natural stone adhesive

GROUTING

Rapid hardening flexible grout, 3 – 20 mm joint width

Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY

Silicone sealant for movement joints

Silicone sealant for use with natural stone